How to Setup and Update V4.94 Digiprog 3

Recently, newly launched V4.94 for Digiprog 3 master programmer has aroused keen interest from many users. Under this case, two related questions put forward by a majority of users are listed below:

1.How to update Digiprog 3 to the newest V4.94

Except you directly buy a newest V4.94 digiprog 3, or else you need to update for your old version one. Whether V4.88 or 4.85, you can smoothly update via Newest Digiprog 3 V4.94 Update Software.

2.How to setup V4.94 Digiprog 3 (or Digiprog 3 setup instruction)

1). Connect Digiprog 3 main unit into the ODB diagnostic socket (Notice: Do Not use cigar lighter lead, or else it will lose the warranty)
2). The Digiprog 3 main unit power on when finish STEP 1, and it turns to load the system.
3). A while later, the screen will display Digiprog 3 software version information, software is marked as a unique 12 digit electronic serial number.
4). Then the screen will appear with a disclaimer regarding the use of machine.
5). Click “Check/Tick” to start using the digiprog 3 odometer master programmer.
6). It needs to input password to enter into the system. The default password is “1”.
7). Welcome the main interface. You are also allowed to check the software version marked red on the following picture.
8). Select the function you need to do and follow the screen instruction.